GENERAL
KUKJE MACHINERY CO., LTD.
33
◈ Important
¾ Do not start the engine without coolant.
¾ Use clean, fresh water and anti-freeze to fill the
radiator.
¾ When the anti-freeze is mixed with water, the
anti-freeze mixing ratio must be less than 50%.
¾ Securely tighten radiator cap. If the cap is loosen
or improperly fitted, water may leak out and the
engine could overheat.
Coolant
capacity(with
recovery tank)
2100
2400(h)
2800(h)
3.8 L
4.0 U.S.qts
1.0 gal
< Flush cooling system and changing coolant
(Continued) >
◆ Anti-freeze
If it freezes, cooling water can damage the
cylinders and radiator. When it may be necessary the
ambient temperature falls below 0℃(32℉) to remove
coolant water after operating or to add anti-freeze to
it.
1. There are two types of anti-freeze available; use
the permanent type for this engine.
2. Before adding anti-freeze for the first time, clean
the radiator interior by pouring fresh water and
draining it a few times.
3. The procedure for mixing the water and anti-
freeze differs according to the make of the anti-
freeze and the ambient temperature.
7. DISASSEMBLING AND SERVICING
To Next Page
Loading...
