FRONT AXLE
KUKJE MACHINERY CO., LTD.
56
4. CHECKING, DISASSEMBLING AND SERVICING
< Front gear case >
1. Remove the knuckle arm(Left side only).
2. Remove the axle flange(2).
3. Remove the external snap ring(3).
4. Remove the bevel gear case(4) from front gear
case(1).
5. Remove the oil seal(5).
6. Remove the ball bearing(6).
7. Remove the internal snap ring(7) and remove the
ball bearing(8).
8. Remove the bevel gear shaft(9) with ball bearing.
▷ Reassembling
9 Apply liquid gasket to joint face of the axle
flange(2) and front gear case(1) after removing
the water, oil and stuck liquid gasket.
9 Tighten the axle flange mounting screws and
nuts diagonally in several steps.
9 Install the oil seal(5) of bevel gear case, noting
its direction as shown in the figure.
M10
48.0 to 56.0 Nm
4.9 to 5.7 kgfm
35.5 to 41.2 ft-lbs
Knuckle arm
mounting
screw
M12
103.0 to 117.7 Nm
10.5 to 12.0 kgfm
76.0 to 86.8 ft-lbs
Tightening
torque
Axle flange mounting
screw
48.1 to 55.9 Nm
4.9 to 5.7 kgfm
35.5 to 41.2 ft-lbs
*. PART NAME
1) Front gear case 2) Cover gear case
3) External snap ring 4) Bevel gear case
5) Oil seal 6) Ball bearing
7) Internal snap ring 8) Ball bearing
9) Bevel gear shaft
(3)
(1)
(6)
(5)
(4)
To Next Page
Loading...
