Brocade Communications Systems MLX Series Hardware Installation Guide

100 Brocade MLX Series and NetIron XMR Hardware Installation Guide
53-1003821-01
Installing a Brocade MLX-32 router
2
Before installation, plan the location and orientation of the device relative to other equipment in
the rack. For cooling purposes, allow a minimum of six inches of space between the front and back
of the device, and walls or other obstructions.
Because you will need to use a mechanical lift to move and install the device, make sure you allow
enough space to operate the lift. You will also need at least two people to slide the router off the lift
and into the rack.
Once you have completed the preliminary installation preparations (refer to “Preliminary rack
mount installation steps” on page 94), follow these steps to mount your 32-slot router in a 4-post
rack or open cabinet.
1. Remove the factory-installed mounting brackets from the router chassis.
2. Attach the front right and left mounting brackets to the chassis using 12 8-32 Phillips flat head
screws (provided). Refer to Figure 68.
FIGURE 68 Attach front right and left mounting brackets to the router chassis

Brocade Communications Systems MLX Series Specifications

General

Brand	Brocade Communications Systems
Model	MLX Series
Category	Network Router
Language	English