Brocade Communications Systems MLX Series - Page 307

Brocade MLX Series and NetIron XMR Hardware Installation Guide 291
53-1003821-01
Replacing fan assemblies
7
5. Orient the upward deflector on the fan assembly faceplate so that the exhaust will flow upward
and the holes in the upward deflector align with the holes where the screws secure the handle
to the fan assembly faceplate. Refer to Figure 170 in step 4.
6. Place the handle over the upward deflector aligning the handle with the screw holes and
secure the handle to the upward deflector and fan assembly faceplate with the two screws.
Refer to Figure 171.
FIGURE 171 Upward deflector oriented correctly between the handle and fan assembly faceplate