TABLE 10 2x100GbE CFP2 Chassis Support (continued)
Ports Chassis Supported Description
NOTE
XMR not supported.
CFP2 optics for 2x100GbE
The 2x100GbE CFP2 interface module is 802.3ba compliant, supports CFP2-based optics, and can be used with existing Brocade
MLXe Series interface modules. The 2x100GbE interface module requires high-speed fabric modules.
NOTE
2x100GbE CFP2 interface modules will boot in turbo mode if all modules in the chassis are Gen-2 modules.
You must insert CFP2-compliant ber-optic transceivers in each port you intend to use. CFP2-compliant transceivers provide an optical
or physical medium-dependent (PMD) interface for single- or multi-mode ber that can be used with either the LAN physical layer (PHY)
or WAN physical layer (WAN PHY).
For a list of supported 2x100GbE CFP2-compliant ber-optic transceivers that are available from Brocade, refer to the latest version of
the Brocade Optics Family Data Sheet.
For more information about ber-optic transceivers and associated cabling, refer to Installing a ber-optic transceiver on page 197.
Power supply requirements for 2x100GbE modules
For power supply requirements for the 2x100GbE modules, refer to Hardware
Specications on page 271.
Router modules
Brocade NetIron MLXe Series Hardware Installation Guide
38 53-1004203-04
To Next Page
Loading...
Need help?
General
