Brocade Communications Systems NetIron MLXe Series User Manual

PBIF Recovery
In the event PBIF gets locked up, PBIF recovery is activated by default with the option to activate PBIF recovery through the
system-monitoring pbif lp-reset-recovery command.
Syntax
system-monitoring pbif lp-reset-recovery
no system-monitoring pbif lp-reset-recovery
Command Default
PBIF is locked up.
Examples
In the event PBIF is locked up, PBIF recovery is activated by default. However, if necessary you may activate PBIF recovery
through the system-monitoring pbif lp-reset-recovery command.
device# config
device(config)# system-monitoring pbif lp-reset-recovery
device(config)# exit
device# write memory
device# reload
To deactivate PBIF recovery perform the no system-monitoring pbif lp-reset-recovery command.
device# config
device(config)# no system-monitoring pbif lp-reset-recovery
device(config)# exit
device# write memory
device# reload
History
Release version Command history
5.7.00 This command was introduced.
2x100GbE CFP2 P2010 specications
P2010 specications are shown for the 2x100GbE CFP2 optics based high density blade.
TABLE 11 2x100GbE CFP2 P2010
Specications
Component Gen 2 Cards 2x100GbE CFP2 Cards
Processor MPC8548E P2010
Processor Version 0x8021_0022 0x8021_1051
System Version 0x8031_0021 0x80e3_0021
Core Version E500V2 E500V2
Clock Speed 1.3GHz 1.2Ghz
Cache Support 32KB L1 instruction cache
32KB L1 data cache
32KB L1 instruction cache
32KB L1 data cache
Router modules
Brocade NetIron MLXe Series Hardware Installation Guide
53-1004203-04 39

Brocade Communications Systems NetIron MLXe Series Specifications

General

Brand	Brocade Communications Systems
Model	NetIron MLXe Series
Category	Network Router
Language	English