Brocade Communications Systems NetIron MLXe Series User Manual

TABLE 11 2x100GbE CFP2 P2010 Specications (continued)
Component Gen 2 Cards 2x100GbE CFP2 Cards
512KB L2 cache 512KB L2 cache
Security Engine Yes Yes, enhanced SEC2 Interface
DDR Support DDR/DDR2 DDR2/DDR3
2x100GbE CFP2 DDR3 SDRAM memory specications
DDR3 SDRAM memory for the 2x100GbE CFP2 optics based high density blade, is shown in the following table.
TABLE 12 2x100GbE CFP2 DDR3 SDRAM Memory Specications
Feature Gen 2 Cards 2x100GbE Cards
DDR type DDR2 DDR3
DDR size 2 GB 4GB
NOTE
For NetIron 5.7 release only: 2GB of
SDRAM memory is usable out of
4GB.
Data rate Up to 533 Mbps Up to 800 Mbps
BR-MLX-10GX20-X2 and BR-MLX-100GX2-CFP2-X2 Router Software
BR-MLX-10GX20-X2 and BR-MLX-100GX2-CFP2-X2 scalability for IPv4 and IPv6 routes
In release 5.8.00a, the maximum number of routes supported with the BR-MLX-10GX20-X2 and BR-MLX-100GX2-CFP2-X2
modules has been scaled to 2.4M for IPv4 and 1.8M for IPv6. The -X2 scaling software is compatible with both MR2-M and MR2-X
management modules so that you can deploy M, X, and -X2 modules in the same device.
NOTE
MR2 management modules require High Speed Switch Fabric modules.
Router modules
Brocade NetIron MLXe Series Hardware Installation Guide
40 53-1004203-04

Brocade Communications Systems NetIron MLXe Series Specifications

General

Brand	Brocade Communications Systems
Model	NetIron MLXe Series
Category	Network Router
Language	English