Brother BM-2000 - Page 87

11 PART REPLACEMENT METHOD
BM-2000
83
4. Loosen the three screws of the lower feed unit as shown in the illustration, and push the feed motor toward the back.
5. Loosen the set screws which are securing the lower roller and its drive pulley (in 2 places for each part).
6. Move the lower roller shaft in the direction shown in the illustration and replace the lower roller.
Actual view
Feed motor
Screw (Hexagonal bolt)
Screw (socket bolt)
Pulley
Lower roller
At this time, check the D cut position of the
shaft in preparation for the next step.
Lower roller shaft