Brother DCP-8065DN

Confidential
5-31
5.1.9 ADF Unit
(1) Remove the four cup S M3x6 Taptite screws, remove the FG harness and then remove the
Shield cover.
Fig. 5-18
(2) Remove the cup S M3x6 Taptite screw, remove the ADF FG harness and FB FG harness.
(3) Disconnect the Connector from the Driver PCB.
(4) Disconnect the two Connectors from the Main PCB.
Fig. 5-19
Shield cove
r
Taptite, cup S M3x6
Taptite, cup S M3x6
FG harness
Driver PCB
Connecto
r
(ADF motor harness)
FB FG harness
ADF FG harness
Main PCB
Connectors
(ADF relay harness)
Taptite, cup S M3x6
<Left side>
<Left side>
Main PCB
Driver PCB