8-1 Confidential
8.1 ENTRY INTO THE MAINTENANCE MODE
Press the [Menu] and [Start] keys. Next press the [ ] key four times to make the machine enter
the maintenance mode.
TIP: FAX models equipped with numerical keypads can enter the maintenance mode in the same
way as conventional models; that is, by pressing the [Menu], [*], [2], [8], [6] and [4] keys in
this sequence.
The machine beeps for approx. one second and displays “
” on the LCD,
indicating that it is placed in the initial stage of the maintenance mode, a mode in which the
machine is ready to accept entry from the keys.
To select one of the maintenance-mode functions listed in Section 8.2, press the [
] key or [ ] key
to display any function code on the LCD. Then press the [OK] key.
(The details of each maintenance-mode function are described in Section 8.4.)
NOTE:
- To exit from the maintenance mode and switch to standby, press the [9] key twice in the initial
stage of the maintenance mode.
- Pressing the [Stop/Exit] key after entering only one digit restores the machine to the initial stage
of the maintenance mode.
- If an invalid function code is entered, the machine resumes the initial stage of the maintenance
mode.
To Next Page
Loading...
