2-44
Confidential
Replace
Toner
Open the Top
Cover.
Pull out the drum
unit with toner to
be replaced.
Press the green
lever.
Replaced toner.
Dot counter of the toner
cartridge (black) or develop
roller counter has reached the
upper limit was detected.
4C01 2-59
Dot counter of the toner
cartridge (yellow) or develop
roller counter has reached the
upper limit was detected.
4C02 2-59
Dot counter of the toner
cartridge (magenta) or develop
roller counter has reached the
upper limit was detected.
4C03 2-59
Dot counter of the toner
cartridge (cyan) or develop
roller counter has reached the
upper limit was detected.
4C04 2-59
During printing, dot counter of
color toner cartridge or develop
roller counter has reached the
upper limit was detected.
4C05 2-59
Replace WT
Box
Replace the Waste
Toner Box inside
the machine.
After the waste toner sensor
detected that the waste toner
box was almost full, pages more
than the specified number have
been printed.
4800 2-58
Screen Init.
Fail
Remove any
material which is
on the
touchscreen.
An error occurred while
initializing the touch panel.
D800 2-81
Self-
Diagnostic
Turn the power off,
then on again.
Leave the machine
for 15 min.
Some fuser unit errors occurred
at power-ON or upon recovery
from sleep mode.
6901 2-65
Will automatically
restart within 15
minutes.
After the error was detected at
the fuser unit, power was turned
ON again and the error is being
checked. (If power is turned
OFF and ON after error code
6901 occurred, this code is
displayed for about 15 minutes.)
6902 2-65
Short paper Open the Back
Cover and then
press [Retry].
The registration rear sensor
detected that the paper loaded
in the T1 was smaller than the
specified size.
8D01 2-71
Size Error Specify the correct
paper size for Tray
1.
When printing from the T1, the
size of paper specified from the
driver set the size which was not
supported by the T1.
9702 2-73
Error message
Description
Error
codes
Refer
to:
First line Second line
To Next Page
Loading...
