Section 03 ENGINES
Subsection 05 (TOP END)
A02C2AA
1
TYPICAL
1. Properly seated all around
Install sleeve then shouldered sleeve over puller
rod.
1
A02C2BA
2
TYPICAL — INSTALLATION OF SLEEVE KIT
1. Sleeve
2. Shouldered sleeve
Screw (LH threads) extracting nut.
Pull out piston pin no. 27 by unscrewing puller
until shouldered sleeve end is flush with thrust
washer of piston pin bearing.
A02C2CA
TYPICAL — PISTON PIN EXTRACTION
13
A02C2DA
2
TYPICAL
1. Sleeve inside bearing
2. Thrust washer
3. Shouldered sleeve end
Remove puller. Pull out shouldered sleeve care-
fully.
A02C2EA
TYPICAL
102
mmr2005-072
To Next Page
Loading...
