btsr SMART KTF 2000 - Page 102

SMART KTF 2000 – KTF/RW Operation
3B-34 - SMART KTF 2000
1.6) METR TARGET (Available SMART KTF-2000 only)
Press to enable the parameter programming
OFF=Function disabled; to enable it press and hold down
for 3 seconds
Set the desired Target (meters)
increases the value by 1
decreases the value by 1
+ increases the value by 1000
+ decreases the value by 1000
2.1) EXIT TENSION = P2.1
Press
to enable the parameter programming
VV.V = Value of P2.1 EXIT TENSION parameter, i.e. the tension value of the
device when the machine is stationary or out of the yarn working zone
with INC/DEC de-activated. If you set a value greater than or lower than
the value set with MAIN TENSION parameter you may control the
deceleration phase of KTF device. This parameter can be enabled (setting
a value ranging from 0.2 to 100 g) or disabled (OFF) using the
CONTROL button.
When it is disabled, it assumes the value previously set with 1.1) MAIN TENSION
parameter.
Press
to move to the next parameter.