User Manual – Rev AJ California Instruments
4.2.10 RS Menu SETUP REGISTE
4-19: SETUP REGISTERS Menu
allows the user to store and recall complete instrument setups
. A total of 8 non-volatile setup registers is available, numb
or Series II, num
Figure
The SETUP REGISTERS menu ,
including transient program lists ered
sequentially from 0 through 7. (F ber of registers is 16).
The following entries can be found in the SETUP REGISTERS menu:
Entry Description
RECALL REGISTER
e
VIEW/EDIT REGISTER isplay the contents of a
e
register will be recalled and the new values
ave the new
values and make them active.
SAVE REGISTER Save present instrument setup to a register number selected by
the user. The numeric data entry keypad should be used to
enter a number between 0 and 7 (15). Once the ENTER key is
pressed, all settings are saved. A message will appear at the
bottom of the screen to confirm the save operation.
Recall instrument setup from a register number selected by the
user. The numeric data entry keypad should be used to enter a
number between 0 and 7 (15). Once the ENTER key is
pressed, all settings are recalled. A message will appear at th
bottom of the screen to confirm the recall operation.
The View/Edit entry can be used to d
setup register before it is recalled. After the user enters a
register number to view or edit and presses the ENTER key, th
PROGRAM screen will appear. All parameters that will be
changed by recalling the register will be blinking. If ENTER is
pressed again, the
take effect. To edit the register content, change all parameters
that need to be changed. Pressing ENTER will s
104 MX Series
To Next Page
Loading...
