User Manual - Rev AJ California Instruments
9.2 Opt dditi al AC V e Rangeion -HV: A on oltag
The -HV option prov f 0-400 VRMS. There is
no equivalent 200 VRMS range associated with the -HV option but the standard 0-150 V RMS
S remain availa if t -HV s installe
If the -HV option is installed, there will be three volta nges that ca selected from
PROGAM 1 menu. ( /300/400 r than the alues, all o erations re e
same. Note however that the -HV range is AC coup nd as such o no DC outpu
capability. Thus, whenever the 400 V range is selected, the output mode is automatically set to
AC MODE and other
Since the –HV option range is AC coupled, the lower frequency limit on the –HV range is 45 Hz
As stated before, the –HV (and –XV) range is AC (transformer) coupled and as such cannot
pass any DC component from the waveform generator. This means that any arbitrary waveform
form with
ides an additional AC only output voltage range o
and 0-300 V RM ble even he option i d.
ge ra n be the
150 ). Othe range v ther op main th
led a ffers t
modes cannot be selected.
and not the 16 Hz that applies to the standard 150/300V ranges. The upper frequency limit
remains the same.
Arbitrary waveforms
created by the user that is to be used in the –HV range cannot have any DC offset. The MX
firmware will generate an error message is an attempt is made to select a custom wave
DC offset while in the –HV range.
MX Series
190
To Next Page
Loading...
