California Instruments MX30-1 - Page 228

User Manual - Rev AJ California Instruments
FREQU
te.
 or 1 minute.
e) will terminate the test at any time.
VOLT UNBALANCE
se only in the following sequence:
 112V for 1 minute.
ute.
ea d on three phase systems to include all three phases if the coupling is
set to all.
The
 key (backspace) will terminate the test at any time.
PHASE DIFFERENCE
This test applies to three phase systems only. The phase angle for the selected phase will
change relative to phase A in the following sequence:
If phase B is selected:
 23
 24
r 1 minute.
te.
VOLTA
output voltage by 2.5V rms over a period of one second. The test will last
for 2 minutes. The
 key (backspace) will terminate the test at any time.
FREQU C
This test will vary the output frequency by 4Hz over a period of one minute. The test will last
for 4 minutes. The
 key (backspace) will terminate the test at any time.
WAVEF
This test will generate a 5% THD voltage distortion on the output voltage waveform. The
distortion is caused by using a clipped sine wave. The test will last for 1 minute. The
 key
ENCY
This test will change the output frequency in the following sequence:
 393Hz for 1 minute.
 407Hz for 1 minu
400Hz f
The
 key (backspac
This test will change the output voltage for the selected pha
 118V for 1 min
 115V for 1 minute.
The test will be rep te
 6 for 1 minute.
 4 for 1 minute.
 240 fo
If phase C is selected:
 116 for 1 minu
 124 for 1 minute.
 120 for 1 minute
GE MODULATION
This test will vary the
EN Y MODULATION
ORM DISTORTION
(backspace) will terminate the test at any time.
MX Series
228