User Manual - Rev AJ California Instruments
Note: Changing from stop to start wi t an
record for the watt-hour meter. To re e
position from the start position and the previous data will be reset to zeros.
WATT HR, POWER and PK CURR will display the data for the phase selected with the phase
key. If the ph d for all ph as
POWER fields will show the sum of all phases. PK CURR will remain at the last selected phase.
Note: Changing Mode of operation from single phase to three phases while the Watt-hour
meter is in the active state will generate an error: “Input buffer full”. This error will halt the
measurements. To clear the error, the Watt-hour meter must be switched to the stopped state.
It is advised that the Watt-hour meter should be set to the stop state before changing the mode
of operation.
ll stop the measuremen
start the measurements, th
d will maintain the last data
field is toggled to the stop
ase is selecte ases in a two or three ph e system, the WATT HR and
MX Series
238
To Next Page
Loading...
