Wireless Flash Photography
N
248
4
Set [Flash mode: E-TTL II].
5
Set [Wireless func.] to [0].
6
Set [Channel].
Set the transmission channel (1-4) to
the same one as the slave unit.
7
Set [Firing group] to [1All].
8
Take the picture.
Set the camera and take the picture
in the same way as with normal flash
shooting.
To terminate wireless flash shooting,
set [
Wireless func.
] to [
Disable
].
Setting [E-TTL II meter.] to [Evaluative] is recommended.
Firing a test flash is not possible with the slave unit.
To Next Page
Loading...
