Canon iR5000 - Installing the NE Controller-A1; Installation

COPYRIGHT © 2000 CANON INC. 2000 2000 2000 2000 CANON iR5000/iR6000 REV.0 JULY 2000
CHAPTER 3 INSTALLATION
3-26 S
7. Installing the NE Controller-A1
Installation herein is to the iR5000/6000. For how to make various settings
and points to note and check (operations), see the Installation Procedure
that comes with the machine.
7.1 Installation
Checks/remarksStep
1
2
3
4
Work
Remove the upper cover of the controller. (See
the Installation Procedure.)
Connect the plug of the AC adapter to the con-
troller. (See the Installation Procedure.)
Remove the four screws [1], and detach the face
plate [2] of the rear upper cover.
Remove the rear upper cover, and free the 8-pin
cable [3] used to connect the controller from the
cable clamp; then, let the cable hang as shown.
Be sure not to route the cable in the area
indicated (by dashed line) of the DC control-
ler PCB to avoid malfunction of the ma-
chine.
[1]
[2]
[3]
Keep the cable out
Download Free Service Manual at http://printer1.blogspot.com