Canon J1 - Page 7

0
0
0-7
0-7
Removing the Positioning Plate Unit -----------------------------------------4-28
Removing the Saddle Delivery Tray Unit -----------------------------------4-28
Removing the Upper Delivery Guide -----------------------------------------4-29
Removing the Inlet Feed Unit --------------------------------------------------4-29
Consumable Parts and Cleaning Points ------------------------------ 4-31
Removing the Stapler ------------------------------------------------------------4-31
Removing the Buffer Roller -----------------------------------------------------4-32
Removing the Return Roller ----------------------------------------------------4-32
Removing the Swing Unit Static Charge Eliminator ----------------------4-33
Removing the Inlet Static Charge Eliminator ------------------------------4-34
Removing the Stitcher Unit -----------------------------------------------------4-35
PCB ----------------------------------------------------------------------------- 4-36
Removing the Finisher Controller PCB --------------------------------------4-36
Action on replacing the nisher controller PCB ---------------------------4-36
Removing the Saddle Stitcher Controller PCB ----------------------------4-36
Other Parts ------------------------------------------------------------------- 4-37
Removing the Paper Folding Roller ------------------------------------------4-37
Removing the No.1 Flappers and the No.2 Flappers --------------------4-39
5
Adjustment
Outline ---------------------------------------------------------------------------5-2
Main adjustment -------------------------------------------------------------------- 5-2
Adjustment item ----------------------------------------------------------------------------- 5-2
The setting of the function ---------------------------------------------------------------- 5-4
Basic Adjustment --------------------------------------------------------------5-7
Adjusting the Stacker Alignment Position ----------------------------------- 5-7
Adjusting the Staple Position --------------------------------------------------- 5-7
Adjusting the Height of the Swing Roller ------------------------------------ 5-8
Adjusting the Saddle Staple Position ----------------------------------------5-10
Adjusting the Saddle Alignment Position------------------------------------5-10
Adjusting the Processing Tray Return Amount --------------------------- 5-11
Adjusting the Processing Tray Return Speed. ----------------------------- 5-11
Initializing the RAM on Finisher -----------------------------------------------5-12
Adjusting the Bias Line of Saddle Delivery Paper -----------------------5-12
Overview -------------------------------------------------------------------------------------5-12
Adjustment ----------------------------------------------------------------------------------5-12
Function Setting Operation ----------------------------------------------------5-15
Adjustment at Time of Parts Replacement --------------------------- 5-17
Action on replacing the nisher controller PCB ---------------------------5-17
Adjusting the Stitcher Unit ------------------------------------------------------5-18
6
Installation
How to Utilize This Installation Procedure ------------------------------6-2
When using the parts included in the package ----------------------------- 6-2
Symbols in the Illustration ------------------------------------------------------- 6-2
Product Name ------------------------------------------------------------------6-2
Checking Before Installation -----------------------------------------------6-3
Checking the Installation Site --------------------------------------------------- 6-3
Installing the Accessories -------------------------------------------------------- 6-3
Points to Note on installation ---------------------------------------------------- 6-4
Check Items when Turning OFF the Main Power-------------------------- 6-4
Checking the Contents ------------------------------------------------------6-5
Unpacking -----------------------------------------------------------------------6-6
Unpacking Procedure ------------------------------------------------------------- 6-6
Installation Procedure --------------------------------------------------------6-9
Preparing the Finisher for Installation ----------------------------------------- 6-9
Connecting to the Host Machine ----------------------------------------------6-10
Attaching the Labels etc --------------------------------------------------------- 6-11
Operation Check ------------------------------------------------------------ 6-13
Operation Check ------------------------------------------------------------------6-13
Adjusting the Tilt ------------------------------------------------------------- 6-14
Check the Tilt ----------------------------------------------------------------------6-14
Adjusting the Tilt -------------------------------------------------------------------6-15
Appendix
Service Tools ----------------------------------------------------------------------ii
Solvents and Oils --------------------------------------------------------------------- ii
Special Tools --------------------------------------------------------------------------- ii
General Circuit Diagram ------------------------------------------------------- iii
Staple Finisher-J1 --------------------------------------------------------------------iii
Booklet Finisher-J1 ------------------------------------------------------------------- v