Appendix B Default Patterns List
B-19
The pattern has six blocks of horizontal and
vertical lines in different densities in four
corners and the center. They are 1-pixel ON
/ 1-pixel OFF, 2-pixel ON / 2-pixel OFF and
3-pixel ON / 3-pixel OFF respectively that is
used to check the resolution.
The pattern has all kinds of dense dots,
horizontal and vertical lines (all are 1-pixel
ON/ 1-pixel OFF) in four corners and the
center. They are used to check the
resolution.
This is for phosphor persistence inspection.
Use Speed On parameter to choose the
moving speed. The larger the value the
faster the speed. Use Speed Off parameter
to determine the size of a small square. The
larger the value the smaller the size. The first
parameter of Blink Draw determines the
amount of small squares by adding 1 to the
value. The second parameter of Blink Draw
determines the following:
1. The path is a rectangle when set to a
clockwise direction.
2. The path is a rectangle when set to a
counterclockwise direction.
3. The path is a straight line when set to an
oblique direction.
4. The path is a circle when set to a
clockwise direction.
5. The path is a circle when set to a
counterclockwise direction.
BITMAP displays the natural picture.
No.: The number of natural picture. The
range is from 1 to 999.
DEV. SELECT: It selects to read the natural
picture from internal or USB disk.
INTERNAL: Read from internal
USB DISK: Read from USB disk
X, Y: The location is at the upper left corner
of the natural picture.
X: The range is from 0 to 4095.
Y: The range is from 0 to 2047.
The internal can save 100 natural pictures by
default. The natural pictures are read by USB
disk if over 100.
The pattern is all composed of “H”. The font
type is 5 7.
To Next Page
Loading...