Chroma 63600-2 - Page 192

Programmable DC Electronic Load 63600 Series Operation & Programming Manual
5-60
The return value is 0 when the channel does not exist or no sink
current.
Query Syntax: FETCh:ALLCurrent?
Return Parameters:<aard>, [Unit = Ampere]
Query Example: FETC:ALLC?
Return Example: 0, 0, 0, 0, 5.12, 0, 12, 0
FETCh:ALLVoltage?
Type: Channel-Independent
Description: Returns the voltage measured at the input of the all load channels.
The return value is 0 when the channel does not exist or no voltage
input.
Query Syntax: FETCh:ALLVoltage?
Return Parameters:<aard>, [Unit = Voltage]
Query Example: FETC:ALLV?
Return Example: 1.2, 2, 0, 0, 10.2, 0, 0, 0
FETCh:ALLPower?
Type: Channel-Independent
Description: Returns the power measured at the input of the all load channels.
The return value is 0 when the channel does not exist or no input.
Query Syntax: FETCh:ALLPower?
Return Parameters:<aard>, [Unit = Watt]
Query Example: FETC:ALLP?
Return Example: 1.2, 2, 0, 0, 10.2, 0, 0, 0
FETCh:AH?
Type: Channel-Specific
Description: Returns the ampere-hour measured in timing mode.
Query Syntax: FETCh:AH?
Return Parameters:<NR2>, [Unit = Ampere-hour]
Query Example: FETC:AH?
Return Example: 3.15
FETCh:CURRent?
Type: Channel-Specific
Description: Returns the current measured at electronic load input.
Query Syntax: FETCh:CURRent?
Return Parameters:<NR2>, [Unit = Ampere]
Query Example: FETC:CURR?
Return Example: 3.15
FETCh:CURRent:PEAK+?
Type: Channel-Specific
Description: Returns the peak+ current measured at electronic load input in CZ
mode.
Query Syntax: FETCh:CURRent:PEAK+?
Return Parameters:<NR2>, [Unit = Ampere]
Query Example: FETC:CURR:PEAK+?
Return Example: 3.15
FETCh:FREQuency?
Type: Channel-Specific
Description: Returns the frequency measured in frequency sweep mode or sine