5-9
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Chapter 5 Setting Up and Managing Shared Profile Components
Network Access Restrictions
This section contains the following procedures:
• Adding a Shared Network Access Restriction, page 5-9
• Editing a Shared Network Access Restriction, page 5-11
• Deleting a Shared Network Access Restriction, page 5-13
Adding a Shared Network Access Restriction
To add a shared NAR, follow these steps:
Step 1 In the navigation bar, click Shared Profile Components.
Result: The Shared Profile Components page appears.
Step 2 Click Network Access Restrictions.
Step 3 Click Add.
Result: The Network Access Restriction page appears.
Step 4 In the Name box, type a name for the new shared NAR.
Note The name can contain up to 32 characters. Leading and trailing spaces are
not allowed. Names cannot contain the following four characters:
[ ] , /
Step 5 In the Description box, type a description of the new shared NAR.
Step 6 To permit or deny access based on IP addressing, follow these steps:
Note This step is performed for IP-based restrictions where an IP connection
exists. For other restriction types, see About Network Access
Restrictions, page 5-6.
a. Select the Define IP-based access descriptions check box.
b. To specify whether you are listing addresses that are permitted or denied,
from the Table Defines list, select the applicable value.
To Next Page
Loading...
Need help?
General