Chapter 7 Setting Up and Managing User Accounts
Basic User Setup Options
7-10
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Setting User Callback Option
Callback is a command string that is passed to the access server. You can use a
callback string to initiate a modem to call the user back on a specific number for
added security or reversal of line charges.
To set the user callback option, follow these steps:
Step 1 Perform Step 1 through Step 3 of Adding a Basic User Account, page 7-5.
Result: The User Setup Edit page opens. The username being added or edited
appears at the top of the page.
Step 2 Under Callback in the User Setup table, select the applicable option. Choices
include the following:
• Use group setting—Select if you want this user to use the setting for the
group.
• No callback allowed—Select to disable callback for this user.
• Callback using this number—Select and type the complete number,
including area code if necessary, on which to always call back this user.
Note The maximum character length for the callback number is 199
characters.
• Dialup client specifies callback number—Select to enable the
Windows 95/98/ME or Windows NT/2000 dialup client to specify the
callback number.
• Use Microsoft NT/2000 callback settings—Select to use the settings
specified for Windows NT/2000 callback. If a Windows account for a user
resides in a remote domain, the domain in which Cisco Secure ACS resides
must have a two-way trust with that domain for the Microsoft NT/2000
callback settings to operate for that user.
Note The dial-in user must have configured software that supports
callback.
To Next Page
Loading...
