6-27
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Chapter 6 Setting Up and Managing User Groups
Configuration-specific User Group Settings
Setting IP Address Assignment Method for a User Group
Perform this procedure to configure the way Cisco Secure ACS assigns IP
addresses to users in the group. The four possible methods are as follows:
• No IP address assignment—No IP address is assigned to this group.
• Assigned by dialup client—Use the IP address that is configured on the
dialup client network settings for TCP/IP.
• Assigned from AAA Client pool—The IP address is assigned by an IP
address pool assigned on the AAA client.
• Assigned from AAA server pool—The IP address is assigned by an IP
address pool assigned on the AAA server.
To set an IP address assignment method for a user group, follow these steps:
Step 1 In the navigation bar, click Group Setup.
Result: The Group Setup Select page opens.
Step 2 From the Group list, select a group, and then click Edit Settings.
Result: The Group Settings page displays the name of the group at its top.
Step 3 From the Jump To list at the top of the page, choose IP Address Assignment.
Step 4 In the IP Assignment table, do one of the following:
• Select No IP address assignment.
• Select Assigned by dialup client.
• Select Assigned from AAA Client pool. Then, type the AAA client IP pool
name.
• Select Assigned from AAA pool. Then, select the AAA server IP pool name
in the Available Pools list and click —> (right arrow button) to move the
name into the Selected Pools list.
Note If there is more than one pool in the Selected Pools list, the users in
this group are assigned to the first available pool in the order listed.
To Next Page
Loading...
