11-65
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Chapter 11 Working with User Databases
Token Server User Databases
Configuring an RSA SecurID Token Server External User Database
Cisco Secure ACS supports the RSA SecurID token server custom interface for
authentication of users. You can create only one RSA SecurID configuration
within Cisco Secure ACS.
Before You Begin
You should install and configure your RSA SecurID token server before
configuring Cisco Secure ACS to authenticate users with it. For information
about installing the RSA SecurID server, refer to the documentation included with
your token server.
Make sure you have the RSA ACE Client for Windows 2000 software.
To configure Cisco Secure ACS to authenticate users with an RSA token server,
follow these steps:
Step 1 Install the RSA client on the Cisco Secure ACS server:
a. Log in to the Cisco Secure ACS Windows server with administrative
privileges.
b. Run the Setup program of the ACE Client software, following setup
instructions provided by RSA.
Note Do not restart your Windows server when installation is complete.
c. Locate the ACE Server data directory, for example, /sdi/ace/data.
d. Get the file named sdconf.rec and place it in your Windows directory:
%SystemRoot%\system32.
For example:
\winnt\system32
e. Make sure the ACE server hostname is in the Windows local host file:
\Windows directory\system32\drivers\etc\hosts
f. Restart your Windows server.
g. Verify connectivity by running the Test Authentication function of your ACE
client application. You can run this from Control Panel.
Step 2 In the navigation bar, click External User Databases.
To Next Page
Loading...
Need help?
General