Chapter 7 Setting Up and Managing User Accounts
Advanced User Authentication Settings
7-42
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Step 5 Do one of the following:
• If you are finished configuring the user account options, click Submit to
record the options.
• To continue to specify the user account options, perform other procedures in
this chapter, as applicable.
Setting Ascend RADIUS Parameters for a User
The Ascend RADIUS parameters appear only if all the following are true:
• A AAA client has been configured to use RADIUS (Ascend) in Network
Configuration.
• The Per-user TACACS+/RADIUS Attributes check box is selected under
Advanced Options in the Interface Configuration section.
• User-level RADIUS (Ascend) attributes you want to apply have been enabled
under RADIUS (Ascend) in the Interface Configuration section.
Ascend RADIUS represents only the Ascend proprietary attributes. You must
configure both the IETF RADIUS and Ascend RADIUS attributes. Proprietary
attributes override IETF attributes.
The default attribute setting displayed for RADIUS is
Ascend-Remote-Addr.
Note To hide or display Ascend RADIUS attributes, see Setting Protocol Configuration
Options for Non-IETF RADIUS Attributes, page 3-16. A VSA applied as an
authorization to a particular user persists, even when you remove or replace the
associated AAA client; however, if you have no AAA clients of this (vendor) type
configured, the VSA settings do not appear in the user configuration interface.
To configure and enable Ascend RADIUS attributes to be applied as an
authorization for the current user, follow these steps:
Step 1 Perform Step 1 through Step 3 of Adding a Basic User Account, page 7-5.
Result: The User Setup Edit page opens. The username being added or edited is
at the top of the page.
To Next Page
Loading...
Need help?
General