Chapter 8 Establishing Cisco Secure ACS System Configuration
CiscoSecure Database Replication
8-26
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Scheduling Replication
You can schedule when a primary Cisco Secure ACS sends its replicated database
components to a secondary Cisco Secure ACS. For more information about
replication scheduling options, see Outbound Replication Options, page 8-18.
Note Replication cannot occur until the secondary Cisco Secure ACSes are configured
properly. For more information, see Configuring a Secondary Cisco Secure ACS,
page 8-21.
Before You Begin
For each secondary Cisco Secure ACS of this primary Cisco Secure ACS, ensure
that you have completed the steps in Configuring a Secondary Cisco Secure ACS,
page 8-21.
Ensure correct configuration of the AAA Servers table of this primary
Cisco Secure ACS. For each secondary Cisco Secure ACS of this primary
Cisco Secure ACS, this Cisco Secure ACS must have an accurately configured
entry in its AAA Servers table. For more information about the AAA Servers
table, see AAA Server Configuration, page 4-20.
To schedule when a primary Cisco Secure ACS replicates to its secondary
Cisco Secure ACSes, follow these steps:
Step 1 Log in to the HTML interface on the primary Cisco Secure ACS.
Step 2 In the navigation bar, click System Configuration.
Step 3 Click CiscoSecure Database Replication.
Note If this feature does not appear, click Interface Configuration, click
Advanced Options, and select the CiscoSecure ACS Database
Replication check box. Also, verify that the Distributed System Settings
check box is selected; if not, select the Distributed System Settings
check box.
Result: The Database Replication Setup page appears.
To Next Page
Loading...
Need help?
General