Chapter 4 Setting Up and Managing Network Configuration
AAA Client Configuration
4-18
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
Editing a AAA Client
You can use this procedure to edit the settings for a AAA client configuration.
Note You cannot directly edit the name of a AAA client; rather, you must delete the
AAA client entry and then re-establish the entry with the corrected name.
Before You Begin
For descriptions of the options available while editing a AAA client
configuration, see AAA Client Configuration Options, page 4-11.
For Cisco Secure ACS to provide AAA services to a AAA client, you must ensure
that gateway devices between AAA clients and Cisco Secure ACS allow
communication over the ports needed to support the applicable AAA protocol
(RADIUS or TACACS+). For information about ports used by AAA protocols,
see AAA Protocols—TACACS+ and RADIUS, page 1-6.
To edit a AAA client, follow these steps:
Step 1 In the navigation bar, click Network Configuration.
Result: The Network Configuration page opens.
Step 2 Do one of the following:
• If you are using NDGs, click the name of the NDG to which the AAA client
is assigned. Then, click the name of the AAA client.
• To edit a AAA client when you have not enabled NDGs, click the name of the
AAA client from the AAA Client Hostname column of the AAA Clients
table.
Result: The AAA Client Setup For Name page appears.
Step 3 In the AAA Client IP Address box, type the correct IP address assigned to the
AAA client, as applicable (up to 32 characters).
Step 4 In the Key box, type the correct shared secret, as applicable.
Note For correct operation, the identical key must be configured on the AAA
client and Cisco Secure ACS. Keys are case sensitive.
To Next Page
Loading...
Need help?
General