Cisco 2509 - Router - EN - Configuring Cisco IOS;PIX RADIUS Settings for a User Group

Chapter 6 Setting Up and Managing User Groups
Configuration-specific User Group Settings
6-38
User Guide for Cisco Secure ACS for Windows Server
78-14696-01, Version 3.1
• Configuring Cisco VPN 5000 Concentrator RADIUS Settings for a User
Group, page 6-43
• Configuring Microsoft RADIUS Settings for a User Group, page 6-45
• Configuring Nortel RADIUS Settings for a User Group, page 6-46
• Configuring Juniper RADIUS Settings for a User Group, page 6-48
• Configuring BBSM RADIUS Settings for a User Group, page 6-49
Step 7 To continue specifying other group settings, perform other procedures in this
chapter, as applicable.
Configuring Cisco IOS/PIX RADIUS Settings for a User Group
The Cisco IOS/PIX RADIUS parameters appear only when both the following are
true:
• A AAA client has been configured to use RADIUS (Cisco IOS/PIX) in
Network Configuration.
• Group-level RADIUS (Cisco IOS/PIX) attributes have been enabled in
Interface Configuration: RADIUS (Cisco IOS/PIX).
Cisco IOS/PIX RADIUS represents only the Cisco VSAs. You must configure
both the IETF RADIUS and Cisco IOS/PIX RADIUS attributes.
Note To hide or display Cisco IOS/PIX RADIUS attributes, see Setting Protocol
Configuration Options for Non-IETF RADIUS Attributes, page 3-16. A VSA
applied as an authorization to a particular group persists, even when you remove
or replace the associated AAA client; however, if you have no AAA clients of this
(vendor) type configured, the VSA settings do not appear in the group
configuration interface.