Cisco 7931G - Make Conference Using Off-Hook Abbreviated Dial; Transfer Call Using Off-Hook Abbreviated Dial; Make Call Using Off-Hook Abbreviated Dial with Call on Hold; Make Call Using Fast Dial

•
If you use a shared line, Hold Reversion rings only on the phone that put the call on hold, not on the
other phones that share the line.
•
Your system administrator determines the duration between Hold Reversion alerts.
•
When a call is chaperoned, the call chaperone cannot use Hold.
Put Call on Hold
Procedure
Step 1
Make sure that the appropriate call is highlighted.
Step 2
Press .
Remove Call from Hold on Current Line
Procedure
Step 1
For the flashing held call, press one of the following buttons:
•
•
•
Step 2
If there are multiple held calls, highlight the appropriate call and press Resume or press .
Multiple Calls
You can switch between multiple calls on multiple lines.
Then...If you want to...
Press (flashing) for the line that you are switching to.
Switch to a held call on
another line
Press (flashing). Any active call is placed on hold and the selected call resumes.
Switch from a connected
call to answer a ringing
call
Cisco Unified IP Phone 7931G User Guide for Cisco Unified Communications Manager 9.0 (SCCP and SIP)
25
Calling Features
Put Call on Hold