Cisco 7931G - Add New Fast Dial Code Without Using PAB Entry; Search for Fast Dial Codes; Place Call Using Fast Dial Code; Delete Fast Dial Code

AutoAnswer with Headset or Speakerphone
When AutoAnswer is enabled, your phone answers incoming calls automatically after a few rings. Your
system administrator configures AutoAnswer to use either the speakerphone or a headset. You may use
AutoAnswer if you receive a high volume of incoming calls.
Then...If you...
Keep headset mode active (in other words, keep ( ) illuminated), even
when you are not on a call.
To keep headset mode active, do the following:
•
Press EndCall to hang up.
•
Press New Call or Dial to place new calls.
If your phone is set up to use AutoAnswer in headset mode, calls are
automatically answered only if ( ) is illuminated. Otherwise, calls ring
normally and you must manually answer them.
Use AutoAnswer with
a headset
Keep the handset in the cradle and headset mode inactive ( ( ) unlit).
Otherwise, calls ring normally and you must answer them manually.
Use AutoAnswer with the
speakerphone
Tip
AutoAnswer is disabled when Do Not Disturb is active.
Cisco Unified IP Phone 7931G User Guide for Cisco Unified Communications Manager 9.0 (SCCP and SIP)
57
Handset, Headset, and Speaker
AutoAnswer with Headset or Speakerphone