2-15
Cisco ASR 1000 Series Aggregation Services Routers Hardware Installation Guide
OL-13208-11
Chapter 2 Cisco ASR 1000 Series Routers Component Overview
Cisco ASR 1000 Series Route Processor
Table 2-7 lists the Cisco ASR 1000 Series Route Processors connectors and description.
MIN Minor Amber Minor alarm indicator. Ambient air
temperature is beyond normal operating
range of 40ºC. For example: if the RP
software determines that an unknown card
has been installed or if the card has failed,
the card can power it off or set a minor
alarm.
DISK HD Internal hard drive
LED
Flashing Green Activity indicator.
Off No activity.
DISK USB External USB Flash
LED
Flashing Green Activity indicator.
Off No activity.
DISK BF Internal USB
bootflash LED
Flashing Green Activity indicator.
Off No activity.
BITS I/F
Mode
CARRIER
LED Off Out of service or not configured.
Solid Green In frame and working properly.
Amber Fault or loop condition exists.
DTI
ModeCAR
RIER
for Cisco
ASR1000-
RP2
LED Off Warmup, Free-run, or Holdover.
Solid Green Normal or bridging.
Amber Fast.
LINK 10/100/1000 RJ-45
Interface LED
Solid Green Link with no activity.
Flashing Green Link with Activity.
Off No link.
Table 2-6 Cisco ASR 1000 Series Route Processor LEDs (continued)
LED Label LED Color —State Behavior Description
Table 2-7 Cisco ASR 1000 Series Route Processor Connectors
Label Type Description
ACO Audible Cutoff button A recessed button to cut off the audible alarm. This
is triggered when the critical, major, or minor LED
is set.
0 USB0 interface Side-by-side USB connector used with memory
sticks or smart cards for secure key distribution
1 USB1 interface Side-by-side USB connector used with memory
sticks or smart cards for secure key distribution
BITS RJ-45 connector Indicates BITS timing reference.
MGMT
ETHERNET
One RJ-45 jack for
copper Ethernet
Management Port
The route processor has an ENET port with a RJ-45
connector to attach a management device or
network for network management.
To Next Page
Loading...
