Use copper conductors only. Statement 1025Warning
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection authority
or an electrician if you are uncertain that suitable grounding is available. Statement 1024
Warning
Hazardous voltage or energy is present on the backplane when the system is operating. Use caution when
servicing. Statement 1034
Warning
Class 1 laser product. Statement 1008Warning
Class 1 LED product. Statement 1027Warning
Laser radiation is present when the system is open. Statement 1009Warning
Do not stare into the laser beam. Statement 1010Warning
Class I(CDRH) and Class 1M (IEC) laser products. Statement 1055Warning
Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do not
view directly with optical instruments. Viewing the laser output with certain optical instruments (for
example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye hazard.
Statement 1056
Warning
There is the danger of explosion if the battery is replaced incorrectly. Replace the battery only with the
same or equivalent type recommended by the manufacturer. Dispose of used batteries according to the
manufacturer’s instructions. Statement 1015
Warning
Do not touch or bridge the metal contacts on the battery. Unintentional discharge of the batteries can cause
serious burns. Statement 341
Warning
Cisco ASR 1000 Series Router Hardware Installation Guide
117
Preparing Your Site for Installation
General Safety Warnings
To Next Page
Loading...
Need help?
General
