Cisco IP Phone 6851

Assign a Ring Tone to an Extension
Procedure
Step 1
On the Configuration Utility page, select Admin Login > advanced > Voice > Ext(n), where (n) is the number
of an extension.
Step 2
Under Call Feature Settings, use the Default Ring (n) drop-down list box to specify one of the following:
•
No Ring
•
Choose one of the available 12 ring tones.
Step 3
Click Submit All Changes.
Configure the Audio Settings
The user can modify volume settings by pressing the volume control button on the phone, then pressing the
Save softkey.
Procedure
Step 1
Click Admin Login > advanced > Voice > User.
Step 2
In the Audio Volume section, configure a volume level between 1 and 10, with 1 being the lowest level:
• Ringer Volume—Sets the ringer volume.
• Speaker Volume—Sets the volume for the full-duplex speakerphone.
• Headset Volume—Sets the headset volume.
• Handset Volume—Sets the handset volume.
• Electronic HookSwitch Control—Enables or disables the EHS feature.
Step 3
Click Submit All Changes.
User Access Control
The Cisco IP Phone respects only the “ua” user access attribute. For a specific parameter, the “ua” attribute
defines access by the user account to the administration web server. If the “ua” attribute is not specified, the
phone applies the factory default user access for the corresponding parameter. This attribute does not affect
access by the admin account.
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
93
Assign a Ring Tone to an Extension