Cisco IP Phone 6851

Network Configuration Fields
Table 7: Ethernet Configuration Submenu
DescriptionDefaultField Type
or Choices
Field
Enables you to turn 802.1x authentication on or turn it off. Valid
options are:
•
On
•
Off
OffDevice
authentication
802.1x
authentication
• Transaction status—Indicates different authentication status
when you turn on 802.1x in the Device authentication field.
◦ Disabled—This is default status.
◦ Connecting—Indicates 802.1x authentication is
initiated in the device.
◦ Authenticated—Indicates 802.1x authentication is
established in the device.
• Protocol—Specifies the protocol of the server.
DisabledTransaction status
Allows you to select speed and duplex of the network port.
If the phone is connected to a switch, configure the port on the
switch to the same speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you must change the PC
Port config option to the same setting.
AutoAuto
10MB half
10MB full
100 MB half
100MB full
100 half
1000 full
Switch port config
Allows you to select Speed and duplex of the Computer (access)
port.
If the phone is connected to a switch, configure the port on the
switch to the same speed/duplex as the phone, or configure both
to autonegotiate.
If you change the setting of this option, you must change the
Switch Port config option to the same setting.
AutoAuto
10MB half
10MB full
100 MB half
100MB full
100 half
1000 full
PC port config
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
27
Configure the Network from the Phone