Cisco IP Phone 6851

DescriptionParameter
Played instead of the Dial Tone when there are unheard messages in
the caller’s mailbox.
MWI Dial Tone
Played when all calls are forwarded.Cfwd Dial Tone
Informs the local caller that the far end has placed the call on hold.Holding Tone
Played to all parties when a three-way conference call is in progress.Conference Tone
Played when a call has been successfully switched tosecure mode. It
should be played only for a short while (less than 30 seconds) and at a
reduced level (less than -19 dBm) so it does not interfere with the
conversation.
Secure Call Indication Tone
Specifies the tone transmitted when the paging feature is enabled.Page Tone
Played when an alert occurs.Alert Tone
Played when the Mute button is pressed to mute the phone.Mute Tone
Played when the Mute button is pressed to unmute the phone.Unmute Tone
Audible notification tone played when a system error occurs.System Beep
Provides the ability to configure an audio indication for call pickup.Call Pickup Tone
Distinctive Ring Patterns
DescriptionParameter
Cadence script for distinctive ring 1.
Defaults to 60(2/4).
Cadence 1
Cadence script for distinctive ring 2.
Defaults to 60(.3/.2, 1/.2,.3/4).
Cadence 2
Cadence script for distinctive ring 3.
Defaults to 60(.8/.4,.8/4).
Cadence 3
Cadence script for distinctive ring 4.
Defaults to 60(.4/.2,.3/.2,.8/4).
Cadence 4
Cadence script for distinctive ring 5.
Defaults to 60(.2/.2,.2/.2,.2/.2,1/4).
Cadence 5
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
173
Cisco IP Phone Web Page