Cisco IP Phone 6851

DescriptionParameter
Interval for sending out RTCP sender reports on an active connection.
It can range from 0 to 255 seconds.
Default: 0
RTCP Tx Interval
Select IPv4 or IPv6.
Default: IPv4
If the phone is in dual-mode and has both ipv4 and ipv6 addresses, it
will always include both addresses in SDP by attributes "a=altc …
If IPv4 address is selected, then ipv4 address has higher priority than
ipv6 address in SDP and indicates that phone prefers using ipv4 RTP
address.
If the phone has only ipv4 address or ipv6 address, SDP does not have
ALTC attributes and RTP address is specified in “c=” line.
SDP IP Preferences
SDP Payload Types
DescriptionParameter
G722 Dynamic Payload type.
Default: 96
G722.2 Dynamic Payload
iLBC Dynamic Payload type.
Default: 97
iLBC Dynamic Payload
iSAC Dynamic Payload type.
Default: 98
iSAC Dynamic Payload
OPUS Dynamic Payload type.
Default: 99
OPUS Dynamic Payload
AVT dynamic payload type. Ranges from 96-127.
Default: 101
AVT Dynamic Payload
INFOREQ Dynamic Payload type.INFOREQ Dynamic Payload
H264 BPO Dynamic Payload type.
Default: 110
H264 BP0 Dynamic Payload
H264 HP Dynamic Payload type.
Default: 110
H264 HP Dynamic Payload
G711u codec name used in SDP.
Default: PCMU
G711u Codec Name
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
164
Cisco IP Phone Web Page