Cisco IP Phone 6851

DescriptionParameter
Allows you to enter port number of the phone web user interface.
Default:
•
80 for protocol HTTP.
•
443 for protocol HTTPS.
If you specify a port number other than the default value for that
protocol, you must include the nondefault port number in the server
URL.
Example: https://192.0.2.1:999/admin/advanced
Web Server Port
Allows you to enable or disable local access to the phone web user
interface. Select Yes or No from the drop-down menu.
Default: Yes
Enable Web Admin Access
Allows you to enter password for the administrator.
Default: No password
Admin Password
Allows you to enter password for the user.
Default: Blank
User Password
Allows you to make the phone menus and options that the phone users
see as read-only fields.
Phone-UI-readonly
Allows you to restrict the menus and options that phone users see when
they use the phone interface. Choose yes to enable this parameter and
restrict access.
Default: No
Specific parameters are then designated as “na” or “ro” using provisioning
files. Parameters designated as “na” will not appear on the phone
interface. Parameters designated as “ro” will not be editable by the user.
Phone-UI-User-Mode
Network Settings
DescriptionParameter
Allows you to select the internet protocol mode in which the phone
operates. Options are: IPv4 Only, IPv6 Only, and Dual Mode. In dual
mode, the phone can have both IPv4 and IPv6 addresses.
Default: Dual Mode
IP Mode
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
153
Cisco IP Phone Web Page