DescriptionParameter
Dial plan script for the selected extension.
The dial plan syntax allows the designation of three parameters for use with a
specific gateway:
• uid – The authentication user-id
• pwd – The authentication password
• nat – If this parameter is present, use NAT mapping.
Separate each parameter with a semi-colon (;).
Dial Plan
Inbound caller ID numbers can be mapped to a different string. For example, a
number that begins with +44xxxxxx can be mapped to 0xxxxxx. This feature has
the same syntax as the Dial Plan parameter. With this parameter, you can specify
how to map a caller ID number for display on screen and recorded into call logs.
Caller ID Map
Enables or disables URI dialing.Enable URI Dialing
Enter a comma-separated list of emergency numbers. When one of these numbers
is dialed, the unit disables processing of CONF, HOLD, and other similar softkeys
or buttons to avoid accidentally putting the current call on hold. The phone also
disables hook flash event handling.
Only the far end can terminate an emergency call. The phone is restored to normalcy
after the call is terminated and the receiver is back on-hook.
Maximum number length is 63 characters. Defaults to blank (no emergency
number).
Emergency Number
TR-069
TR-069
DescriptionParameter
Settings that enables or disables the TR-069 function.Enable TR-069
URL of the ACS that uses the CPE WAN Management Protocol. This
parameter must be in the form of a valid HTTP or HTTPS URL. The
host portion of this URL is used by the CPE to validate the ACS
certificate when it uses SSL or TLS.
ACS URL
Username that authenticates the CPE to the ACS when ACS uses the
CPE WAN Management Protocol. This username is used only for
HTTP-based authentication of the CPE.
If the user name is not configured, admin is used as default.
ACS Username
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
205
Cisco IP Phone Web Page
To Next Page
Loading...
