Cisco IP Phone 6851

Configure Call Park with Star Codes
You can configure call park so that the user can put a call on hold and then retrieve the call from either the
user's phone or another phone.
When configuring call park, the Call Park Code and the Call Unpark Code must match the Feature Access
Code configured on the server.
Procedure
Step 1
On the Configuration Utility page, select Admin Login > Advanced > Voice > Regional.
Step 2
Enter *68 in the Call Park Code field.
Step 3
Enter *88 in the Call Unpark Code field.
Step 4
Click Submit All Changes.
Add Call Park to a Programmable Line Key
You can add call park to a line key to enable the user to temporarily store and retrieve calls. Call park is
supported on private lines and shared lines.
Procedure
Step 1
On the Configuration Utility page, select Admin Login > Advanced > Voice > Phone.
Step 2
Select a line key.
Step 3
Select Disabled to disable the extension.
Step 4
In the Extended Function field, enter a string in this format:
For a private line, enter fnc=park;sub=$USER@$PROXY;nme=CallPark-Slot1.
For a shared line, enter fnc=prk;sub=$USER@$PROXY;nme=Call-Park1;orbit=<DN of primary line>.
where:
•
fnc= prk means function=call park
•
sub= 999999 is the phone to which the call parks. Replace 999999 with a numbers.
•
nme= XXXX is the name displayed on the phone for the call park line key. Replace XXXX with a name.
Step 5
Click Submit All Changes.
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
116
Call Park