Cisco IP Phone 6851

DescriptionParameter
Cadence script for distinctive ring 6.
Defaults to 60(.2/.4,.2/.4,.2/4).
Cadence 6
Cadence script for distinctive ring 7.
Defaults to 60(4.5/4).
Cadence 7
Cadence script for distinctive ring 8.
Defaults to 60(0.25/9.75)
Cadence 8
Cadence script for distinctive ring 9.
Defaults to 60(.4/.2,.4/2).
Cadence 9
Control Timer Values (sec)
DescriptionParameter
Delay after far end hangs up before reorder (busy) tone is played. 0 =
plays immediately, inf = never plays. Range: 0–255 seconds. Set to 255
to return the phone immediately to on-hook status and to not play the
tone.
Reorder Delay
Long timeout between entering digits when dialing. The interdigit timer
values are used as defaults when dialing. The Interdigit_Long_Timer
is used after any one digit, if all valid matching sequences in the dial
plan are incomplete as dialed. Range: 0–64 seconds.
Default: 10
Interdigit Long Timer
Short timeout between entering digits when dialing. The
Interdigit_Short_Timer is used after any one digit, if at least one
matching sequence is complete as dialed, but more dialed digits would
match other as yet incomplete sequences. Range: 0–64 seconds.
Default: 3
Interdigit Short Timer
Vertical Service Activation Codes
DescriptionParameter
This code calls the last caller.
Defaults to *69.
Call Return Code
Begins a blind transfer of the current call to the extension specified after the activation
code.
Defaults to *88.
Blind Transfer
Code
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
174
Cisco IP Phone Web Page