Cisco IP Phone 6851

DescriptionParameter
Allows you to select Speed and duplex of the Computer (access) port.
•
Auto
•
10MB half
•
10MB full
•
100 MB half
•
100MB full
•
100 half
•
1000 full
PC Port Config
Specifies if PC port is enabled. Options are Yes or No.PC PORT Enable
Adds the ability to port mirror on the PC port. When enabled, you can
see the packets on the phone. Select Yes to enable PC port mirroring
and select No to disable it.
Enable PC Port Mirror
Specify the syslog server name and port. This feature specifies the server
for logging IP phone system information and critical events. If both
Debug Server and Syslog Server are specified, Syslog messages are
also logged to the Debug Server.
Syslog Server
The debug level from 0 to 2. The higher the level, the more debug
information is generated. Zero (0) means that no debug information is
generated. To log SIP messages, you must set the Debug Level to at
least 2.
Default: 0
Debug Level
IP address or name of the primary NTP server used to synchronize its
time.
Default: Blank
Primary NTP Server
IP address or name of the secondary NTP server used to synchronize
its time.
Default: Blank
Secondary NTP Server
Choose Yes to enable SSLv3. Choose No to disable.
Default: No
Enable SSLv3
VLAN Settings
DescriptionParameter
Choose Yes to enable VLAN. Choose No to disable.Enable VLAN
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
156
Cisco IP Phone Web Page