DescriptionParameter
If enabled, the IP phone redirects the keepalive message when
SIP_301_MOVED_PERMANENTLY is received as the registration
response.
Redirect Keep Alive
Provisioning
Configuration Profile
DescriptionParameter
Allows or denies resync actions.
Default: 160,159,66,150
Provision Enable
The device performs a resync operation after power-up and after each
upgrade attempt when set to Yes.
Default: Yes
Resync On Reset
A random delay following the boot-up sequence before performing the
reset, specified in seconds. In a pool of IP Telephony devices that are
scheduled to simultaneously powered up, this introduces a spread in the
times at which each unit sends a resync request to the provisioning
server. This feature can be useful in a large residential deployment, in
the case of a regional power failures.
Default: 2
Resync Random Delay
Time in 24-hour format (hhmm) to resync the device. When this
parameter is provisioned, the Resync Periodic parameter is ignored.
Default: Blank
Resync At (HHmm)
To avoid flooding the server with simultaneously resync requests from
multiple phones set to resync at the same time, the phone triggers the
resync up to ten minutes after the specified time.
The input value (in seconds) is converted to minutes.
The default value is 600 seconds (10 minutes). If the parameter value
is set to less than 600, the default value is used.
Default: 600
Resync At Random Delay
Time in seconds between periodic resyncs. If this value is empty or
zero, the device does not resync periodically.
Default: 3600
Resync Periodic
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
167
Cisco IP Phone Web Page
To Next Page
Loading...
