DescriptionParameter
The interval applied in the event of an upgrade failure. The firmware
upgrade error timer activates after a failed firmware upgrade attempt
and is initialized with this value. The next firmware upgrade attempt
occurs when this timer counts down to zero.
Default: 3600 seconds
Upgrade Error Retry Delay
A firmware upgrade script that defines upgrade conditions and associated
firmware URLs. It uses the same syntax as Profile Rule.
Use the following format to enter the upgrade rule:
protocol://server[:port]/profile_pathname
For example:
tftp://192.168.1.5/image/sip88xx.10-3-1-9-3PCC.loads
If no protocol is specified, TFTP is assumed. If no server-name is
specified, the host that requests the URL is used as the server name. If
no port is specified, the default port is used (69 for TFTP, 80 for HTTP,
or 443 for HTTPS).
Default: Blank
Upgrade Rule
Syslog message issued at the start of a firmware upgrade attempt.
Default: $PN $MAC -- Requesting upgrade
$SCHEME://$SERVIP:$PORT$PATH
Log Upgrade Request Msg
Syslog message issued after a firmware upgrade attempt completes
successfully.
Default: $PN $MAC -- Successful upgrade
$SCHEME://$SERVIP:$PORT$PATH -- $ERR
Log Upgrade Success Msg
Syslog message issued after a failed firmware upgrade attempt.
Default: $PN $MAC -- Upgrade failed: $ERR
Log Upgrade Failure Msg
For more information about the Provisioning page, see the Cisco IP Phone 6800 Series Multiplatform Phones
Provisioning Guide.
CA Settings
DescriptionParameter
The URL to download Custom CA.
Default: Blank
Custom CA Rule
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
170
Cisco IP Phone Web Page
To Next Page
Loading...
