DescriptionParameter
Enables you to keep the Display Name private.
Select Yes if you want the IP phone to enclose the string (configured
in the Display Name) in a pair of double quotes for outbound SIP
messages.
Default: Yes.
Escape Display Name
Enables support for the BroadSoft Talk Package that lets users answer
or resume a call by clicking a button in an external application.
Default: No
Talk Package
Enables support for the BroadSoft Hold Package, which lets users place
a call on hold by clicking a button in an external application.
Default: No
Hold Package
Enables support for the BroadSoft Conference Package that enables
users to start a conference call by clicking a button in an external
application.
Default: No
Conference Package
If set to yes, unit includes c=0.0.0.0 syntax in SDP when sending a SIP
re-INVITE to the peer to hold the call. If set to no, unit will not include
the c=0.0.0.0 syntax in the SDP. The unit will always include a=sendonly
syntax in the SDP in either case.
Default: Yes
RFC 2543 Call Hold
If set to yes, the phone uses a different random call-ID for registration
after the next software reboot. If set to no, the Cisco IP phone tries to
use the same call-ID for registration after the next software reboot. The
Cisco IP phone always uses a new random Call-ID for registration after
a power-cycle, regardless of this setting.
Default: No.
Random REG CID on Reboot
Specifies the lowest TCP port number that can be used for SIP sessions.
Default: 5060
SIP TCP Port Min
Specifies the highest TCP port number that can be used for SIP sessions.
Default: 5080
SIP TCP Port Max
Provides the option to take the caller ID from PAID-RPID-FROM,
PAID-FROM, RPID-PAID-FROM, RPID-FROM, or FROM header.
Default: PAID-RPID-FROM
Caller ID Header
Cisco IP Phone 6800 Series Multiplatform Phones Administration Guide
159
Cisco IP Phone Web Page
To Next Page
Loading...
