CHAPTER 8
Configuring Session Manager
This chapter contains the following sections:
•
Information About Session Manager, page 85
•
Guidelines and Limitations for Session Manager, page 85
•
Configuring Session Manager, page 86
•
Verifying the Session Manager Configuration, page 88
Information About Session Manager
Session Manager allows you to implement your configuration changes in batch mode. Session Manager works
in the following phases:
• Configuration session—Creates a list of commands that you want to implement in session manager
mode.
• Validation—Provides a basic semantic check on your configuration. Cisco NX-OS returns an error if
the semantic check fails on any part of the configuration.
• Verification—Verifies the configuration as a whole, based on the existing hardware and software
configuration and resources. Cisco NX-OS returns an error if the configuration does not pass this
verification phase.
• Commit— Cisco NX-OS verifies the complete configuration and implements the changes atomically
to the device. If a failure occurs, Cisco NX-OS reverts to the original configuration.
• Abort—Discards the configuration changes before implementation.
You can optionally end a configuration session without committing the changes. You can also save a
configuration session.
Guidelines and Limitations for Session Manager
Session Manager has the following configuration guidelines and limitations:
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 85
To Next Page
Loading...
