Cisco Nexus 5600 Series - Verifying GIR at Protocol Level

PurposeCommand
Displays the maintenance mode timeout period, after
which the switch automatically returns to normal
mode.
show maintenance timeout
Displays maintenance mode information for Cisco
technical support.
show tech-support mmode
Displays the maintenance-mode section of the running
or startup configuration. The all option includes the
default values.
show {running-‐config | startup-‐config} mmode
[all]
Displays snapshots present on the switch.show snapshots
Displays a comparison of two snapshots. The
summary option displays just enough information
to see the overall changes between the two snapshots.
The ipv4routes and the ipv6routes options display
the changes in IPv4 and IPv6 routes between the two
snapshots.
show snapshots compare snapshot-name-1
snapshot-name-2 [summary | ipv4routes |
ipv6routes]
Displays content of the various sections in a generated
snapshot.
show snapshots dump snapshot-name
Displays the user-specified snapshot sections.show snapshots sections
Displays the current system mode. This command
also displays the current state of the maintenance
mode timer when the switch is in maintenance mode.
show system mode
Verifying GIR at Protocol Level
BGP (Maintenance mode)
Use the show bgp process command to display BGP status in maintenance mode:
switch# show bgp process
BGP Process Information
BGP Process ID : 11725
BGP Protocol Started, reason: : configuration
BGP Protocol Tag : 100
BGP Protocol State : Running (Isolate)
BGP MMODE : Initialized
BGP Memory State : OK
BGP asformat : asplain
BGP attributes information
Number of attribute entries : 1
HWM of attribute entries : 1
Bytes used by entries : 100
Entries pending delete : 0
HWM of entries pending delete : 0
BGP paths per attribute HWM : 3
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
310 OL-31641-01
Configuring GIR (Cisco NX-OS Release 7.3(0)N1(1))
Verifying GIR at Protocol Level