Cisco Nexus 5600 Series - Default Call Home Settings; Configuring Smart Call Home; Registering for Smart Call Home

•
You must have an active service contract for the device that you are configuring.
Default Call Home Settings
Table 23: Default Call Home Parameters
DefaultParameters
4000000Destination message size for a message sent in full
text format
4000000Destination message size for a message sent in XML
format
4000Destination message size for a message sent in short
text format
25SMTP server port number if no port is specified
All for full-text-destination and short-text-destination
profiles. The cisco-tac alert group for the CiscoTAC-1
destination profile.
Alert group association with profile
XMLFormat type
0 (zero)Call Home message level
Configuring Smart Call Home
Registering for Smart Call Home
Before You Begin
•
Know the sMARTnet contract number for your switch
•
Know your e-mail address
•
Know your Cisco.com ID
Procedure
Step 1
In a browser, navigate to the Smart Call Home web page:
http://www.cisco.com/go/smartcall/
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 125
Configuring Smart Call Home
Default Call Home Settings