Cisco Nexus 5600 Series - Removing Module Pre-Provisioning; Verifying the Pre-Provisioned Configuration

switch(config-slot)# provision model N2K-C2232P
switch(config-slot)# exit
Removing Module Pre-Provisioning
You can remove a module that has been pre-provisioned.
Procedure
PurposeCommand or Action
Enters global configuration mode.configuration terminal
Example:
switch# config t
switch(config)#
Step 1
Selects the slot to pre-provision and enters
slot configuration mode.
slot slot
Example:
switch(config)# slot 101
switch(config-slot)#
Step 2
Removes pre-provisioning from the
module.
no provision model model
Example:
switch(config-slot)# no provision model
N2K-C2248T
switch(config-slot)#
Step 3
Exits slot configuration mode.exit
Example:
switch(config-slot)# exit
switch#
Step 4
(Optional)
Copies the running configuration to the
startup configuration.
copy running-config startup-config
Example:
switch# copy running-config startup-config
Step 5
This example shows how to remove a preprovisioned module from a chassis slot:
switch(config)# slot 2
switch(config-slot)# no provision model N5K-M1404
switch(config-slot)#
Verifying the Pre-Provisioned Configuration
To display the pre-provisioned configuration, perform one of the following tasks:
PurposeCommand
Displays module information.show module
Cisco Nexus 5600 Series NX-OS System Management Configuration Guide, Release 7.x
OL-31641-01 35
Configuring Module Pre-Provisioning
Removing Module Pre-Provisioning